LeMond Revolution 250202-2 Owner's Manual page 9

3. Install the base assembly to the body assembly using the included 60mm screw and two 15mm
screws removed from the shipping base. (Figure 1.2)
Begin by starting the longer (60mm) screw through the center arm of the base assembly into the
body assembly. Do not fully tighten to allow the other two screws to thread in easily.
Next, install the two shorter (15mm) screws into the recessed holes near the center foot.
Tighten all three screws.
Load the cassette onto the adapter. (Figure 1.3) See below for instructions on cassette types.
4.
Shimano® 11-Speed
Shimano® 10-Speed
Shimano® 9-Speed
Shimano® 8-Speed
Campagnolo® 11-Speed
Campagnolo® 10-Speed
Campagnolo® 9-Speed
Note:
tor in one orientation. However, it is possible to install them out of order. Before installing the lockring
make sure that the sprockets are in the correct order and the spacers are installed properly. Refer to the
manufacturers documentation if necessary.
5.
Thread the lockring onto the cassette and tighten with a Shimano® locking tool to 40 N m.
Note: Make sure that the cassette spins freely counter-clockwise. If the cassette does not spin freely remove
the lockring, loosen the hub nut, check that the adaptor spacer is installed, and repeat steps 7-9 above
ensuring proper torque on all fasteners.
No spacer is required
Use both the included 1.85mm spacer and a 1mm spacer
Use the included 1.85mm spacer
Use the included 1.85mm spacer
Switch cassette adapters (Pg. 14)
ASSEMBLY INSTRUCTIONS
1.85 mm. spacer
1 mm. spacer
Cassette
FIGURE 1.3
Cassette
Lockring
-
.
9