LeMond Revolution 250202-2 Owner's Manual page 12

5. With the chain resting on the smallest sprocket and the chain stays resting on the
press down gently on the bicycle seat and roll the bicycle forward. As the bicycle rolls forward it will
drop about an inch as the dropouts seat onto the axle. (Figure 3.3)
6.
seated squarely in the dropouts. Both the left and right dropouts should be in contact with the axle
R
of the .
EVOLUTION
Note: Before securing the quick release axle ensure that the bicycle is squarely seated onto the
by lightly pushing the seat from side to side. If the dropouts do not shift on the axle then the bicycle is
secure and the axle can be tightened. If the bicycle seems unstable return to step 4 above and repeat
the process.
7. Tighten the acorn nut on the quick release skewer while holding the lever on the opposite side and
lock the skewer with the lever. (Figure 3.4)
WARNING: SECURELY CLAMPING THE BIKE TO THE REVOLUTION WITH THE CAM ACTION
!
RETENTION DEVICE TAKES CONSIDERABLE FORCE. IF YOU CAN FULLY CLOSE THE CAM LEVER
WITHOUT WRAPPING YOUR FINGERS AROUND THE SEAT STAY OR CHAIN STAY FOR LEVER
AGE, THE LEVER DOES NOT LEAVE A CLEAR IMPRINT IN THE PALM OF YOUR HAND, AND THE
SERRATIONS ON THE WHEEL FASTENER DO NOT EMBOSS THE SURFACES OF THE DROPOUTS,
THE TENSION IS INSUFFICIENT. OPEN THE LEVER; TURN THE TENSION ADJUSTING NUT CLOCK
WISE A QUARTER TURN; THEN TRY AGAIN.
BICYCLE MOUNTING INSTRUCTIONS
R
axle,
EVOLUTION
FIGURE 3.3
R
EVOLUTION
12