Epson Stylus Photo 1390 Service Manual page 97

EPSON Stylus Photo 1390/1400/1410
When installing the APG Assy, make sure that the FLAG
Release Assy is NOT in a released state (with the Upper Paper
Guide down).
Upper Paper Guide
Released
Figure 4-56. Installing the APG Assy
Refer to Figure 4-54, and route the APG Connector Cables
correctly.
DISASSEMBLY AND ASSEMBLY
FLAG Release Assy
Not Released
Disassembly/Assembly Procedures
Match the phase of the APG Assy following the next steps.
1. Match the delta marks of Spur Gear 16 and Combination
Gear 22, 28.8, 32.4.
Combination Gear
22, 28.8, 32.4
Delta Marks
2. At the position where the tab can be identified through the
cutout of the PG Frame, match the delta marks of Spur
Gear 16 and PG Cam (Left).
Spur Gear 16 PG Cam (Left)
Tab
Delta Marks
Figure 4-57. Phase Matching
Tighten the screws in the order shown in
Revision B
Spur Gear 16
Figure 4-55.
97