Epson Stylus Photo 1390 Service Manual page 106

EPSON Stylus Photo 1390/1400/1410
4.2.6.7 Paper EJ Frame Assy
See "4.3.2 Paper EJ Frame Assy" on page 129
C H E C K
P O I N T EJ Frame Assy of Stylus Photo 1390.
1. Remove the Printer Mechanism.
2. Remove the CD-R Unit Housing from the CD/DVD Tray Base by releasing the
Housing from two attaching points to the Tray Base.
3. Remove the Left Frame Support Plate.
4. Put back the rotation position of the Right PG Cam.
5. Remove the four C.B.S. 3x6 screws and two C.B.P. 3x8 screws that secure the
Paper EJ Frame Assy.
Tabs
3
2
Attaching Points
CD/DVD Tray Base Paper EJ Frame Assy
Figure 4-85. Screws that Secure the Paper EJ Frame Assy
DISASSEMBLY AND ASSEMBLY
to remove the Paper
See section 4.2.1.5 on page 82.
See Step 2 in Section 4.2.6.5 on page 98.
1
Tabs
2) C.B.S. 3x6
(8±1 kgf.cm)
4) C.B.P. 3x8
(6±1 kgf.cm)
CD-R Unit Housing
Disassembly/Assembly Procedures
When performing the following procedure, take care not to scratch
C A U T I O N
the Star Wheel.
6. Remove the two Guide Pins on the CD/DVD Tray Base from the Left and Right
CD-R Release Lever Sub Assys.
7. Pull the Star Wheel Roller toward you, and remove the Paper EJ Frame Assy from
the Printer Mechanism while keeping the Assy from coming in contact with the
Right CD-R Release Lever Sub Assy and the tab on the Right CD-R Cover.
4
Left CD-R Release
Lever Sub Assy
Figure 4-86. Removing the Paper EJ Frame Assy
Revision B
Star Wheel Roller
Right CD-R Right CD-R Release
Cover Lever Sub Assy
Guide
pins
Point of contact
106