Epson Stylus Photo 1390 Service Manual page 103

EPSON Stylus Photo 1390/1400/1410
When performing the following procedure, take care not to scratch
C A U T I O N
the Carriage Shaft.
18. To prevent the CR Scale Cover from interfering with the back of the Carriage
Unit, slide the Carriage unit to the left side, shift the Carriage Shaft to the left
direction to remove the Carriage Shaft from both the Main Frame and the Carriage
Unit, release the right end from the Main Frame, and draw out the Carriage shaft.
Interference
point
Carriage
Unit
2
Figure 4-76. Removing the Carriage Shaft
DISASSEMBLY AND ASSEMBLY
CR Scale Cover
Carriage Shaft
3
1
Disassembly/Assembly Procedures
Set the longer end of the Carriage Shaft to the left side.
When the Carriage Shaft is removed, the Plain Spring and Leaf
Spring that are attached to the right end of the Carriage Shaft
may drop off. In such case, be sure to attach them in the order
as shown in the figure below
Carriage Shaft
Left Side
Longer
Figure 4-77. Installing the Carriage Shaft
19. Remove the CR Drive Belt from the Carriage Unit.
CR Drive Belt
Figure 4-78. Removing the CR Drive Belt
Refer to the figure below and install the CR Drive Belt so that its
top and rear sides face the correct way.
With Tooth Surface
Without Tooth Surface
Figure 4-79. Installing the CR Drive Belt
Revision B
Leaf Spring Plain Spring
Right
Side
Shorter
Carriage Unit
Both Surfaces have Tooth
103