Epson Stylus Photo 1390 Service Manual page 83

EPSON Stylus Photo 1390/1400/1410
Insert the Waste Ink Tube with the red line into the Ink Tube.
Waste Ink Tube
Figure 4-18. Installing the Ink Tubes
Make sure that the Waste Ink Tubes are not nipped by the
Printer Mechanism.
Tighten the screws in the order shown in
Secure the bracket of the PictBridge and the Printer
Mechanism together with screw
The following three reassembly instructions does not apply to
Stylus Photo 1390:
When installing the Printer Mechanism, match the positioning
hole of the PictBridge Unit to the dowel of the Lower Housing.
PictBridge Unit
Lower Housing
Figure 4-19. Installing the Printer Mechanism (1)
DISASSEMBLY AND ASSEMBLY
Ink Tube
Figure 4-17.
.
3
Positioning Hole and
Dowel
Disassembly/Assembly Procedures
When installing the Printer Mechanism, check that the
PictBridge Unit cable is secured to the Main Frame with
Acetate tape, and be careful not to pinch it. (For Acetate Tape
position of the PictBridge Unit cable, refer to
on page 105.)
Fix the PictBridge Unit cable to the Lower Housing with acetate
tape as shown below.
• Left edge: Align with the right edge of CN2
• Top edge: Do not cover the chips on the Main board.
CN2
Figure 4-20. Installing the Printer Mechanism (2)
After replacing the Printer Mechanism, be sure to make the
A D J U S T M E N T
R E Q U I R E D
following adjustments.
1. Platen Gap (PG) Adjustment
2. Head Angular Adjustment
3. Bi-D Adjustment
4. First dot position
5. PW Sensor Adjustment
6. PF Deterioration Compensation Counter Reset
7. PF Adjustment
8. PF Adjustment (Bottom Margin)
9. CR Motor Drive Dispersion Measurement Sequence
Refer to Chapter 5 "Adjustment" for details on the adjustments.
Revision B
"PictBridge Unit"
18mm
40mm
Acetate Tape position
(p.132)
(p.132)
(p.132)
(p.133)
(p.133)
(p.133)
(p.133)
(p.133)
(p.133)
83