Epson Stylus Photo 1390 Service Manual page 87

EPSON Stylus Photo 1390/1400/1410
Referring to Figure
After routing the APG Motor Cable to the rib of the ASF Assy,
secure it with the Acetate Tape 2 as shown below.
Figure 4-29. Installing the Acetate Tape 2
When installing the FFC to the connector (CN15), secure it with
acetate tape as shown below.
CN15
Figure 4-30. Installing the Acetate Tape
DISASSEMBLY AND ASSEMBLY
4-28, route each of the Cables and FFCs.
APG Motor Cable
5mm
Acetate Tape 2
FFC
Acetate Tape
3mm
Disassembly/Assembly Procedures
9. Remove the two C.B.S. 3x6 screws that secure the two Guide Roller LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide
Roller LDs.
Guide Roller LD
LD Roller Shaft
Figure 4-31. Removing the Guide Roller LD
Align the Guide Pins and tabs on the Guide Roller LDs with the
positioning holes on the Main Frame.
Revision B
2) C.B.S. 3x6
Front
(8±1 kgf.cm)
Face
Tab
Guide Pin
Guide Roller LD
See Figure 4-31.
87