Epson Stylus Photo 1390 Service Manual page 80

EPSON Stylus Photo 1390/1400/1410
4.2.1.4 Upper Housing
See "4.3.1 Upper Housing" on page 128
C H E C K
P O I N T Housing of the Stylus Photo 1390.
1. Remove the Side Housing. See Section 4.2.1.2 on page 78.
2. Open the Printer Cover and Paper Support.
3. Open the Front Cover. See section 4.2.1.3 on page 79.
4. Remove the four C.B.P. 3x10 screws, three C.B.S. 3x6 screws, and two C.B.P.
3x10 screws that secure the Upper Housing.
8
1
Guide Pin
Printer Cover
Upper
Housing
6
2
Tab
Figure 4-12. Screws that Secure the Upper Housing
DISASSEMBLY AND ASSEMBLY
to remove the Upper
7
Guide Pin
Paper
Support
1) C.B.P. 3x10
(6±1 kgf.cm)
2) C.B.S. 3x6
(6±1 kgf.cm)
15) C.B.P. 3x10
(6±1 kgf.cm)
CD-R Unit
5
4
Tab
Disassembly/Assembly Procedures
5. Disconnect the Panel FFC and CD-R Sensor Cable from connectors CN1 and CN2
on the Switch Board, and release the CD-R Sensor Cable from the tabs of the
Upper Housing.
CN2
CD-R Sensor
Cable
CN1
Guide Pin
3
Figure 4-13. Disconnecting the CD-R Sensor Cable and Panel FFC
6. Remove the Guide Pins from the two tabs shown in
Upper Housing upwards.
Align the Guide Pins with the positioning holes of the Upper
Housing.
When inserting the CD-R Sensor Cable into the Switch Board,
press the connector to make sure that it is firmly installed on
the Switch Board.
9 Referring to
CD-R Sensor Cable.
Tighten the screws in the order shown in
Panel FFC
Tabs
Figure 4-12, and remove the
See Figure 4-12.
Figure 4-13, correctly route the Panel FFC and
Figure 4-12.
Revision B
80