EPSON Stylus Photo 1390/1400/1410
3.
Load unused Ink Cartridges of all colors into the Carriage Unit.
4.
Loosen the screw that secures the Parallelism Adjust Bushing.
5.
Turn the Parallelism Adjust Bushing upward to match the frame edge and the
bottom of the Parallelism Adjust Bushing gear.
When the Parallelism Adjust Bushing is turned upwards, the frame
C A U T I O N
rises up and PG narrows. Make sure that the frame does not come
into contact with the Printhead when performing the following
procedure.
Parallelism Adjust
Positioning Point
Bushing
Screw
Figure 5-5. Setting the Parallelism Adjust Bushing
ADJUSTMENT
Parallelism Adjust
Bushing
Positioning Point
Screw
Adjustment
6.
With its conductor connection portion up, set the Adjustment Gauge in the
specified position (on the left side of the Front Paper Guide).
Setting Position
Rear direction: Match the rear end of the Gauge with the Driven Roller
Shaft of the Upper Paper Guide.
Left direction: Release the left end of the Gauge from the Tab on the Front
Paper Guide in
Conductor Connection Point
Tab
Figure 5-6. Setting the Adjustment Gauge
7.
Move the Carriage Unit onto the Adjustment Gauge.
Moving position
Match the left end of the Gauge with the left end of the Carriage Unit.
Figure 5-7. Moving the Carriage Unit
Revision B
Figure 5-6
Setting Position
Setting Position
141