Epson Stylus Photo 1390 Service Manual page 93

EPSON Stylus Photo 1390/1400/1410
5. Release the coil section of Torsion Spring 24.7 from the tab on the Left CR Shaft
Mounting Plate with tweezers.
Left CR Shaft
Mounting Plate
Torsion Spring 24.7
Figure 4-42. Removing the Torsion Spring 24.7 (1)
6. Remove Torsion Spring 24.7 from the CR Scale following the next steps:
6-1. Bring the coil section to an upright position.
6-2. Push downwards to release foot 1 from the cutout on the Left CR Shaft
Mounting Plate.
6-3. Turn the coil section counterclockwise.
6-4. Remove Torsion Spring 24.7 from the hole on the CR Scale.
Step 6-3
Figure 4-43. Removing the Torsion Spring 24.7 (2)
DISASSEMBLY AND ASSEMBLY
Tab
Step 6-1
Foot 1
Cutout
Step 6-2
Disassembly/Assembly Procedures
7. Turn the CR Scale 90°, and remove it from the tab on the Left CR Shaft Mounting
Plate.
Figure 4-44. Removing the CR Scale
Revision B
Tab
93