Xerox Phaser 4500 Service Manual page 318

1.
Remove the 150-Sheet Paper Cassette (Tray 1).
2. Remove the Print Cartridge, and protect it from light exposure.
3. Remove the Paper Exit Rear Door (PL10.2.21/PL9.1.12) (page 8-5).
4.
Remove the Fuser Assembly (page 8-54).
5.
Lift the 150-Sheet Feeder roller holder assembly upward until it latches into the
lifted position detent.
6. Remove the screw (gold, 8 mm) that attaches the No Paper Sensor Holder.
7. Remove the No Paper Sensor Holder from the 150-Sheet Feeder Assembly.
8.
Release the hooks that secure the No Paper Sensor to the No Paper Sensor
Holder, and remove the No Paper Sensor.
9.
Unplug the cable connector (P/J240) from the No Paper Sensor.
Replacement Note:
Caution
Use care when tightening the screw on the Sensor Holder to avoid pinching and
possibly damaging the wires in the cable harness.
FRU Disassembly 8-29