Resetting All Printer Default Settings (Postscript Nvram) - Xerox Phaser 4500 Service Manual

Resetting All Printer Default Settings (PostScript
NVRAM)
Resetting the PostScript NVRAM restores all printer values stored in the Image
Processor controller NVRAM (including network, printer setup, job defaults, and
margin) to their factory default values. The print counts and the Adobe firmware
serial number are not affected by this reset.
Caution
Before resetting the printer default settings to factory default values, make note
of the current network settings or print a configuration page to record the
customer's current network settings.
You can reset the PostScript NVRAM by:
Using the Main Menu
Using the Service Diagnostics Menu
Using the Front Panel Shortcut
Using the Main Menu
1. From the Main Menu, select Troubleshooting, then press the OK button.
2. Service
Select
3. Reset
Select
4. Select Reset NVRAM and Reset Printer
reset all the settings to their factory default values.
Using the Service Diagnostics Menu
1.
Enter Service Diagnostics.
2. Controller NVRAM
Select
3. With Reset PostScript NVRAM
4.
Enter the password (4370) when prompted.
5. Resetting NVRAM! Are you sure?
When
press the OK button.
The printer then exits Service Diagnostics and reboots. While booting, NVRAM
is reset.
Using the Front Panel Shortcut
1. At power-on, press the Back + OK buttons together.
2. When Password
together within 2 seconds.
6-14
Tools, then press the OK button.
NVRAM, press the OK button.
Access, then press the OK button.
appears, press and hold the Up Arrow + Down Arrow buttons
NOW, then press the OK button to
highlighted, press the OK button.
is displayed, highlight
Phaser 4500 Service Manual
Yes
and