2. Remove the old seal by prying the
locking tabs out with a regular
screwdriver.
The Teflon coated side (which is the
lighter of the two colors) goes against
the tumbler. The seal is then looped in
a "U" shape so the slot edge of the
lighter colored side is to the tumbler
front. Rubber adhesive is used to hold
the seal overlap.
Bend tabs back over seal with a pair of
pliers.
TUMBLER ALSO RIDES AGAINST
LIGHT COLORED SIDE
TUMBLER AND BEL
T
The tumbler is a round cylinder with no
permanently attached front or back.
Tumbler speed is 47 RPM. It is
designed so there is no front or back.
Installation can be made without regard
to which way it came out of a dryer.
To Remove Tumbler and Drive Belt:
1. Remove front panel.
2. Remove tumbler front.
3. Reach under tumbler and remove
drive belt from motor and idler
pulleys.
THIS
SID~AGAINST
TUMBLER BACK
I
4. Slip belt off tumbler.
5. Pull tumbler out of cabinet.
ED/GD401 1090
SECTION 3. SERVICE PROCEDURES
3-20