Maytag 111990" Automatic Dryers Service Manual page 57

MOTOR
SUPPORT
MOTOR PULLEY ADJUSTMENT
Positioning of the pUlley on the motor
shaft is important for proper alignment
with the idler assembly. The distance
from the back of the motor pulley to the
face of the motor support must be 3/8".
A metal gage (Maytag Part No. 38623)
is available which can be used to prop-
erly position the pulley.
To use the gage, simply place the
thicker part against the motor support
and the thinner end between the pulley
and the mounting ring. With the proper
3/8" dimension established, tighten the
pulley set screw.
ED/GD401 1090
When replacing the motor pulley make
sure the set screw aligns with the flat
side of the motor shaft. Tighten set
screw securely.
DRIVE MOTOR AND BASE
1. Remove front panel.
2. Remove tumbler front.
3. Remove tumbler.
4. Remove two screws securing motor
base to base frame.
5. Remove wires from motor and
unhook idler spring.
6. Slide motor base tab from base
frame.
7. Remove motor and blower assembly
from cabinet.
8. Remove blower component from
motor..
Note: When installing motor, be
sure to slide motor base tab into
slot in base frame.
SECTION 3. SERVICE PROCEDURES
3-29