Blower 3 - Maytag 111990" Automatic Dryers Service Manual

BLOWER
RETAINING
RING
COVER FOR
BLOWER
SEAL FOR BLOWER
The felt seal for the blower is secured
to the lip of the cover for the blower. If
a seal is replaced, clean surface and
use Maytag Part No. 55978 rubber
adhesive to hold seal.
COVER FOR BLOWER
1. Remove front panel.
2. Remove tumbler front.
3. Remove six screws holding cover to
blower housing.
4. Remove screw holding cover to
\ base.
5. It is not necessary to remove wires
from thermostats to gain access to
blower. Simply lay blower cover
forward.
ED/GD401 1090
BLOWER
HOUSING
BLOWER IMPELLER
The blower impeller is attached directly
to the motor shaft and behind the
blower cover.
1. Remove blower cover.
2. Remove clip retaining ring.
3. Compress and remove clamp
around hub of impeller.
4. Work impeller back and forth while
pulling off shaft.
BLOWER HOUSING
1. Remove blower impeller.
2. Remove clip retaining ring located
behind blower impeller.
3. Remove four screws holding blower
housing to motor mounting bracket.
SECTION 3. SERVICE PROCEDURES
3-27