Maytag 111990" Automatic Dryers Service Manual page 42

FRONT PANEL REMOVAL
1. Remove screws.
2. Lift up on front panel and swing
bottom of panel away from dryer to
disengage top of panel from dryer
top.
J
UFl'UP
SWING OUT
3. Front panel may be set off to one
side or if necessary, the door switch
EO/GD401 1090
wires may be disconnected and the
front panel removed completely
from the unit.
DOOR SEAL
1. Open door.
2. Grasp one end and pull gasket from
door.
3. When installing the door gasket, the
thicker end fits behind the tabs on
the door.
4. Install one end of the gasket at the
bottom of the door and work the
gasket behind each tab.
Note: It may be necessary to cut 1/2"
from one end of the replacement
gasket.
DOOR REMOVAL
1. Open door.
2. Support door and remove four
screws (two from upper hinge and
two from lower hinge) which hold
the door.
SECTION 3. SERVICE PROCEDURES
3-14