Maytag 111990" Automatic Dryers Service Manual page 35

BUZZER
Many model dryers incorporate a
buzzer which signals the end of the
cycle on all dry selections. The buzzer
is wired in parallel with the timer con-
tacts for the drive motor.
1. See Access To Control Panel Com-
ponents.
2. Remove buzzer by removing one
screw securing mounting bracket to
back-up plate.
3. On some models note the shaft of
buzzer and corresponding slot in
pivot arm of slide lever.
ADJUSTABLE BUZZER -
ADJUSTABLE SLIDE LEVER
The lever on the end of cycle signal can
be adjusted by the customer. The
signal control lever is raised to
increase and lowered to reduce or
eliminate the buzzer tone.
1. Remove buzzer. One screw secures
buzzer to mounting bracket.
2. Remove slide lever with pivot arm.
Note position of pivot arm, slide
lever and retaining plate for future
mounting procedures. Two screws
secure mounting plate for lever.
PUSH-TO-START SWITCH
1. See Access To Control Panel Com-
ponents.
,2. Remove two screws holding switch
\ and bracket to back-up plate.
ED/GD401 1090
AUTO-DRY SWITCH
1. See Access To Control Panel Com-
ponents.
2. Remove switch by taking out two
screws holding switch to back-up
plate.
PRESS CARE SWITCH
1. See Access To Control Panel Com-
ponents.
2. Remove switch.
SECTION 3. SERVICE PROCEDURES
3-1