Atari 400 User Manual page 19

HOOKING THE TV SET 10 THE
COMPUTER CONSOLE
STEP 1
Unplug your N set.
STEP 2
Locate the connector (or connectors) on the
back of the set labeled VHF. Remove the cable
connected there (you may need a screwdriver
for this).
STEP 3
Attach the cable labeled N on the switch box to
the screws labeled VHF on your N set.
STEP 4
Check whether the cable you have just dis-
connected is thick and round (75 ohm) or flat
(300 ohm) .
STEPS
Attach the cable to the TV switch box at the
points labeled 75 ohm or 300 ohm (depending
on which type of cable you have).
STEP 6
If the cable you disconnected in Step 2 w as a 75
ohm (thick and round) cable, you must set your
N to accept a 300 ohm signal. See your N
Owner 's Manual for instructions on how to set
your television for a 300 ohm antenna.
17