Removing Board From Low-Profile Slot - Fujitsu ESPRIMO E Operating Manual

System expansions

Removing board from low-profile slot

► Open the casing (see "Opening the casing").
► Disconnect the cables connected to the board.
► Press on the locking lever in the direction of the arrow (1), unhook it and swing it up in the
direction of the arrow (2).
► Pull the board out of the slot (3).
For cooling, protection against fire, and in order to comply with EMC (electromagnetic
!
compatibility) regulations, you must refit the cover plate.
► Push the rear slot cover plate into the slot (4). Ensure that the point of the cover engages on
the outside of the casing.
► Fold the lock closed in the direction of the arrow (5) and allow it to engage.
► Close the casing (see "Closing the casing").
If you have installed or removed a PCI board, please check the relevant PCI slot settings
i
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
42
1
2
3
5
4
A26361-K690-Z220-1-7619, edition 1