Assembling the system unit
Assembling the system unit
1
²
Place the side cover on the system unit in the direction of the arrow (1) so that the distance (a)
is approx. 10 mm.
²
Push the side cover in the direction of the arrow (2) until it engages.
²
Lock the side cover using the locking slide at the rear (3).
²
Return the system unit to its original position.
²
If you have disconnected cables, reconnect them at the rear.
Installing and removing a board
Observe the notes on installing and removing boards in the chapter
!
Old ISA boards which require a -5 V power supply are not supported.
The number, position and constellation of the board slots on the system board can be found in the
technical manual for the system board. Boards may be installed when the device is shipped.
A26361-K516-Z100-1-7619
2
a
System expansions
3
"Important
notes".
31