Fujitsu ESPRIMO E Operating Manual page 48

System expansions
A
A = Rear panel for low-profile boards
► Place the new rear panel on the casing in the direction of the arrow (1).
► Fasten the new rear panel with the four screws (2).
► Place the power supply in the casing at a slight angle in the direction of the arrow (1).
Make sure that the side lug (a) of the power supply hooks into the notch on the casing panel
provided for it.
► Fold the power supply downward in the direction of the arrow (2).
► Connect the power supply connector (3) to the connections on the mainboard and the drives.
► If necessary, install the board bracket (see "Installing board bracket").
Replace the cross piece (see "Installing the cross-piece").
►
► Close the casing (see "Closing the casing").
40
1
2
3
2
B = Rear panel for long boards
2
1
A26361-K690-Z220-1-7619, edition 1
B
1
2
a
2