Replacing rear panel
►
Open the casing (see "Opening the casing").
►
Remove the cross-piece (see "Removing the cross-piece").
►
If necessary, remove the board bracket (see "Removing board bracket").
►
Disconnect the power supply connector (1) from the mainboard and the drives.
►
Tilt the power supply forward in the direction of the arrow (2) so that the lug (a) unhooks.
►
Carefully lift the power supply out of the casing in the direction of the arrow (3) and lay it next to
the device.
A
A = Rear panel for low-profile boards
►
Remove the four screws (1).
►
Pull the rear panel from the casing in the direction of the arrow (2).
A26361-K690-Z220-1-7619, edition 1
1
2
1
3
2
1
B = Rear panel for long boards
System expansions
a
B
2
1
1
39