Start Feature Programming 'D - Autopage C3-RS-625 Installation Manual

Vehicle
without Turbo
(The
Can not Arm
with
engine
running)
6 +
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds.
3 long chirps & 3 parking light flashes will confirm exit.
START FEATURE "D" PROGRAMMING:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF
position.
2. Push the Valet switch 9 times (holding in on the 9TH push) until four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature 'D' programming mode.
3. Press and release the transmitter button corresponding to the feature
you want to program.
Press One Chirp /
Transmitter LED one pulse
Button Factory
Setting
Exit the programming mode.
1
(3 long chirp & 3 parking light flashes to confirm this exit.)
Tachometer
2 +
Check type (3A)
A> RPM learning – see RPM Learning page 25.
B>
3
Time:
0.6-second
Low check level
4
Start or Stop the system for TESTING & ADJUSTMENT
5
Vehicle
Turbo
system (The
Can be Armed
the with the engine
running and
the engine will
run
after the ignition
is turned off)
Five chirps = Press
same time to control Engine run time for 5 minutes
Two Chirps /
LED two pulse
Default
Voltage
type (go to 3B)
0.8-second (2 chirps), 1.0-second (3 chirps),
Start Crank 1.2-second (4 chirps), 1.4-second (5 chirps),
1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps),
4.0-second (10 chirps),
Hi check level
with
Press
system
buttons at the
same time to
control Engine
run time for 1
by itself
minute
Three Chirps /
LED
pulse
Timer
check
checking type
(go to 3B)
23
Press
and and
buttons at the
same time to
control Engine
run time for 3
minutes
and buttons at the
Four Chirps /
three LED
pulse
Data
Interface
Mode**
four
Bus