Professional 2-way 915 mhz. oled remote car starter & 6 channel alarm system with built-in temperature sensor and two way serial port data link (37 pages)
Page 1
SVMASTER - C3-RS-1000 OLED PROFESSIONAL OLED 2-WAY 915 MHz. FM REMOTE CAR STARTER & 6 CHANNEL ALARM SYSTEM With Built-in Temperature Sensor And Two-way Serial Port Data Link Compatible OPERATION MANUAL THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY http://www.msvmaster.lv...
http://www.msvmaster.lv SVMASTER - OLED REMOTE TRANSCEIVER: A. OLED REMOTE DISPLAY……………………………….…..…………………………………..…………………… 4 The Remote Transceiver, XT-100 OLED CHARGING THE BATTERY ……….………………………………………………………………………….….. 4 MAIN PAGE …………………………………………………………………………………………………………… 5 SELECT THE TRANSCEIVER’S BUTTON CONFIGURATION …………………………………………. 6 SELECT THE TRANSCEIVER FEATURES …………………………………………..………………………. 6 P1-1: Enable / Disable Bi Sound While Pressing Button (7) P1-2: Button Lock Setting (7) P1-3: Melody / Vibration Mode (7) P1-4: Demo Mode (8)
Page 3
http://www.msvmaster.lv SVMASTER - P. DRIVER PAGING / LOST AND FOUND ………………………….…………..……………………..………………...1 7 Q. DOME LIGHT CONVENIENCE DELAY & SUPERVISION ……………………..……………….….………..……..17 R. IGNITION CONTROL THE DOOR LOCK/UNLOCK. ………..………………….……………………………..…..….17 S. TRUNK RELEASE (CHANNEL 3) OUTPUT ………..……………………………………………….……………...….1 7 T. CHANNEL 4 / 5 / 6 TIMER CONTROL OUTPUT ………..……………………………………………….…………..17 U.
Page 4
http://www.msvmaster.lv SVMASTER - REMOTE TRANSCEIVER (TX) A. OLED DISPLAY Name of Transmitter Clock / Timer Door Lock In – Range Indicator Door Alarm Status Temperature Car Jacking Bypass Shock Sensor (Zone 4) Battery Level Engine Running Melody Mode Count Down Timer Parking Timer Vibration Mode Alert Alarm...
Page 5
http://www.msvmaster.lv SVMASTER - Antenna Antenna switch switch OLED Display button button switch switch Button Button Button Button Button Button Button Button Reset Hole B. CHARGE THE BATTERY The unit has a built-in 3.7V lithium polymer battery. If the OLED screen dis play low battery or the icon is flashing, your remote transceiver needs charging.
Page 6
http://www.msvmaster.lv SVMASTER - CR2032 3-Volt Battery AC Power Supply: The remote transceiver equipped AC POWER SUPPLY / AC ADAPTOR (Output Voltage: 4.2VDC – 5.5VDC and with same USB plug), then you can charge the battery indoors. This screen will be displayed while the battery of the Remote Transceiver is...
http://www.msvmaster.lv SVMASTER - While the icon Press button 2 to stop the Push the button and the count down time. flashes . count down timer will be displayed. While icon Push the button, the OLED screen will display individually i.e. daily start timer, flashes .
Page 8
http://www.msvmaster.lv SVMASTER - Note: If 5 seconds of inactivity expires or if the button is pressed, the transceiver features program mode will exit. Spin down the switch Spin down the switch Spin down the switch Spin down the switch to page 1. to page 2.
Page 9
http://www.msvmaster.lv SVMASTER - screen . E- P1- 4. “DEMO MODE”: To display the units demo mode Demo movie playing. Press button 4 to start Press any Button to exit. Spin down the switch the Demo movie . to page 1. E- P2- 1.
Page 10
http://www.msvmaster.lv SVMASTER - D- P2- 3. “LIGHTING FOR OLED” SETTINGS: Example: Set the ON time for the OLED display from seconds to seconds. Press the button and Press button 4 and it Press button 2 to Spin down the switch will display the previous the setting is done.
Page 11
http://www.msvmaster.lv SVMASTER - Press button 3 to set Push the button Press button 2 to set Press button 2 to turn the alert alarm timer the ”minute” digit to OFF the alert alarm While the icon is “30”. This can also be timer or press any and the icon will...
Page 12
http://www.msvmaster.lv SVMASTER - done with the jog shuttle. Press button 3 and the Press button 2 to set While the icon is setting is done. the ”minute” digit to flashing push the ” ” “00”. button to check the daily start timer.
Page 13
http://www.msvmaster.lv SVMASTER - Following the above step to setting Alphabetical to GARAGE DOOR Press button 3 Press button 1 Spin down the and the setting is and the “ ” switch to set done. flashes for the ”R”. setting. English D- P6- 1.
http://www.msvmaster.lv SVMASTER - Channel # 5 Timer Output Programming required Channel # 6 Timer Output Programming required Switching code For 2nd Car Operation. For regular remote transmitter Button Function Selection For Two way Remote transceiver Confirm Button / Back to Main Page For Two way Remote transceiver Feature Selection For Two way Remote transceiver...
Page 15
http://www.msvmaster.lv SVMASTER - remote. F. PASSIVE ARMING (Programming Required) Active arming / disarming is controlling your security system via the remote transmitter. This security system is equipped with an optional Passive Arming feature which allows the security system to arm 30 seconds after the last door is closed.
http://www.msvmaster.lv SVMASTER - (When you are finished with the above procedures, the system's siren stops alarming and the parking lights stop flashing, but the vehicle cannot be started and driven away.) 3. If you use one digit to be a password pin code, skip to Step 6. If you use two digits to be a password pin code, advance to Step 4.
Page 17
http://www.msvmaster.lv SVMASTER - 1.Light impact will trigger the warn-away signal. 2.Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition key will trigger the programmed sequence. The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking lights, and dome light will turn on to alert of an intrusion for 30 seconds.
http://www.msvmaster.lv SVMASTER - *Note : If you use password pin code to double protect the vehicle security, you will need to use it to completely disarm the system. N. SYSTEM’S TRIGGER CHECK Spin up the switch to the page and then press the “Trigger Check”...
http://www.msvmaster.lv SVMASTER - U. MULTI- VEHICLE SECURITY OPREATION: Your remote transmitter can be utilized to control multi- vehicle security system, to program the remote control transmitter to a second vehicle, follow the instructions for Transmitter programming. All programming parameters will be the same except for the following: For Regular Remote Control Transmitter: 1.
http://www.msvmaster.lv SVMASTER - REMOTE START OPERATION: A. TO REMOTE START THE VEHICLE: 1. Press the button on the transmitter. Twice if safety start has been programmed. 2. The parking light will activate to indicate the remote start received the signal. ( A melody sound from your Remote OLED transceiver and “...
http://www.msvmaster.lv SVMASTER - during extreme cold temperatures . WARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle-starting device. A running engine produces dangerous carbon monoxide fumes, which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if it is garaged. Timer Start Operation: 1.
http://www.msvmaster.lv SVMASTER - TEST MODE In this test mode, the system can test the all of the trigger input. The installer can save time to test the sensitivity of the 2-stage shock sensor and optional sensor and without using the traditional arming/disarming procedures to test the sensors.
Need help?
Do you have a question about the C3-RS-1000 OLED and is the answer not in the manual?
Questions and answers