Shutdown Diagnostics; Neutral Safety Switch - Autopage C3-RS-625 Installation Manual

4. Press the
button on the transmitter together for 6 seconds, there will be a
confirmation six chirp with 3 long chirp and parking light flash 3 times
to confirming the system "Start Feature C & D Programming all returns
to factory default setting.
1. Turn the ignition ON then OFF 3 TIMES and stay in OFF position.
2.
Push the Valet switch 14 times (holding in on the 14
with one long chirp is heard then release the valet switch. You are now in the
"Data Bus Reset Setting" programming mode.
Data Bus Reset:
3. Press and hold the
there will be a confirmation six chirps with three long chirps to confirm the
system has reset the data bus.
The unit has the ability to report the cause of the last shutdown of the
remote start system.
Enter:
1. Turn the Ignition 'switch to 'ON position.
2. Press the
3. The LED will now report the last system shutdown by flashing for one
minute in the following grouped patterns:
LED
Flashes
(-) Safety Shutdown input
1
(+) Safety Shutdown input
2 Neutral Safety Switch input
3
5
button first within 3 seconds, then press the
DATA BUS RESET FOR C I 3 INTERFACE
and
SHUT DOWN DIAGNOSTICS:
button on the transmitter.
Shutdown Mode
(Hood)
(Brake) or
fail.
No RPM or
Low Voltage.
Over-rev
buttons at the same time on the transmitter,
1. Close the hood.
2. Check H7/10 White/ Black wire
connection.
1. Check
connection.
2. Move the Enable Toggle Switch to
"ON" position. (If installed.)
3. Move the gear selector to "Park"/
"NEUTRAL" position.
4. Check
connection.
Tachometer Checking Type:
Check H7/9 White/Red wire connection
Voltage Checking Type:
Program the "CHECK LEVEL" from
"Hi Check Level" to "Low Check Level"
28
th
push) until six chirps
H7/3 White/ Violet
H7/4 Black/White
+
wire
wire