Autopage C3-RS-625 Installation Manual page 9

BLACK WIRE — SYSTEM GROUND –
This is the main ground connection of the alarm module. Make this
connection to a solid section of the vehicle frame. Do not connect this
wire to any existing ground wires supplied by the factory wire loom,
make the connection to the vehicle's frame directly.
BROWN WIRE – (-) 200mA HORN OUTPUT (Default) – Programmable
A-2
This wire is provided to use the existing vehicle's horn as the alarm
system's optional's warning audible device. It's a transistorized low
current output, and should only be connected to the low current ground
output from the vehicle's horn switch
This wire can also be programmed for factory system rearm. See program
Table "A" # 2
RED WIRE — SYSTEM POWER (+12V CONSTANT) —
The RED wire supplies power to the system. Connect this wire to a stable
constant +12 volt source.
H5: 2 PIN WHITE CONNECTOR (THE LED STATUS INDICATOR):
The led indicator status should be mounted in a highly visible area such as
top of the dashboard, on top of the shifter console or on dashboard face.
Leave at least 6mm space behind the mounting location for LED housing.
Once a suitable location is chosen, drill a 6mm hole. Run the LED wires
through the hole then press the 2-pin LED housing into the place. Route
the LED wires to the control module.
Brown wire
86
FUSE
To horn
+ 12 V
87
87a
+12V Or Ground
85
Depending On
30
System Requirements
9