Rpm Learning; Voltage Check Type - Autopage C3-RS-625 Installation Manual

While the system is in Start Feature "D" programming mode,
1. Press and release the transmitter
horn chirp indicating you are in features "RPM Learning mode".
2. Start the vehicle with the key. (While the engine is running, the parking
light & LED will flash, if not, please check the tachometer
White/Red wire connection.
3. Press and hold the valet switch for 2 seconds until a long chirp and the
LED light is constant for two seconds. The RPM signal is learned.
4. Once you complete step 3, you can adjust and test "Check Level" as
below:
CHECK LEVEL PROGRAMMING: (TEST & ADJUST)
While the system is in Start Feature "D" programming mode,
1. Press the
2. If everything goes well:
a. Press the
been completed this programming successfully.
b. Press button on the transmitter to exit the program mode. There will
be 3 long chirps & 3 parking light flashes for confirmation.
3. If the crank time is too long, (starter will crank while the engine is
running):
a. Press the
Press
Low position. [1] LED flash,
[1] horn chirp to confirm this setting
b. Repeat the step1 – 4 if necessary.
4. If the crank time is too short, (Engine not running, after starter stops
cranking):
a. Press the
Press
position. [2] LED flash,
[2] horn chirp to confirm this setting
b. Repeat the step1 – 4 if necessary.
Enter Start Feature 'D' Programming Mode:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF
position.
2. Push the Valet switch 9 times (holding in on the 9th push) until four
chirps with a long chirp is heard then release the valet switch. You are
button on the transmitter to start the vehicle.
button on the transmitter to stop engine running. You have
button on the transmitter to stop engine running.
button on the transmitter to set proper "Check Level " to
button on the transmitter to stop engine running.
button on the transmitter to set proper " Check Level " to Hi
VOLTAGE CHECKING TYPE:

RPM LEARNING:

button once, [1] LED flash, [1]
25