Autopage C3-RS-625 Installation Manual page 14

BLACK/WHITE WIRE —
(-) Remote Start Enable Toggle Switch Input
(-)Neutral Safety Switch Input —
When the BLACK/WHITE wire is grounded, the remote start unit is
operable. When this wire is open from ground, the remote start is
disabled.
1. The optional "remote start toggle switch" can be added on to temporarily
disable the Remote Start Device, preventing the
vehicle from being remote started accidentally. This feature is useful if
the vehicle is being serviced or stored in an enclosed area. To disable
the remote start, move the optional remote start enable toggle switch to
the OFF position. To enable the remote start, move the optional remote
start enable toggle switch to the ON position.
2. If needed, this wire can be connected to the PARK/NEUTRAL switch in
the vehicle. (See the TESTING YOUR INSTALLATION GUIDE)
*IMPORTANT NOTE: Directly connect the BLACK/WHITE wire to the
"GROUND" when this wire is not used.
WHITE/VIOLET WIRE: POSITIVE SAFETY SHUT DOWN INPUT
This wire provides an instant shutdown for the remote start, whenever it
gets +12volts. If the brake lights switch in the vehicle switches +12 volts
to the brake light circuit, connect this wire to the output side of the brake
switch. This will allow the remote start to shut down if an attempt is
made to operate the vehicle without the key while running under the
control of the remote start. In most vehicles, in order to shift gear, the
brake pedal must be depressed. The brake input will in turn cause the
remote start unit to shut off. See below diagram.
Switch closes when
brake is depress
WHITE/BLACK WIRE –
NEGATIVE SAFETY SHUT DOWN INPUT —
The WHITE/BLACK wire provides an instant shutdown for the r e mote
start, whenever it is grounded. Connect the wire to the hood pin switch
previously installed. This wire must be routed though a grommet in the
firewall and connected to the hood pin switch.
+12 volts from fuse box
Brake light bulbs
14
To White/ Violet
wire