Introduction - Autopage C3-RS-625 Installation Manual

This Remote Starter with Alarm and Keyless Entry System has been
designed to be installed on fuel-injected vehicles with an automatic
transmission ONLY.
n
Never install this remote starter on a manual transmission vehicle.
n
This system must be installed and wired through a safety switch so it
will not start in any forward or reverse gear.
n
Some automatic transmission vehicles mainly older GM vehicles with
a purple starter wire have a mechanical-type park safety switch instead of
electrical safety switch. The mechanical type does not interrupt the
starter circuit when the transmission is in any gear and does not offer the
100% level of safety required for remote starting purposes. Therefore, our
system should never be installed on any vehicle that uses a mechanical
type park safety switch.
n
Once you install this system, you must verify that the vehicle will not
start in any forward or reverse gear, regardless of the type of vehicle.
n
Read the operation manual for operating.
n
Do not install any component near the brake, gas pedal or steering
linkage.
n
Some vehicles have a factory installed transponder immobilizer
system that can severely complicate the installation. There is a
possibility that
immobilizer-equipped vehicles.
n
Most vehicles have an SRS air bag system. Use extreme care and do
not probe any wires of the SRS system.
n
Disconnect the car battery before beginning work on the vehicle.
n
Check behind panels before drilling any holes. Ensure that no wiring
harness or other components are located behind the panels that would
otherwise be damaged.
n
Do not use conventional crimp lock, bullet on any wiring. Poor wiring,
i.e. taped joints will possibly introduce unreliability into the alarm system
and may result in false alarms or incorrect operation. We suggest
soldering all connection points.
n
Install the wiring neatly under carpets or behind trim to prevent
possible damage to wires.

INTRODUCTION

this system cannot be
3
installed on some