Table of Contents
Advertisement
its commands directly from the CPU of the
theft protection as well as aid in the installation of this product. The RS-232
serial harness is provided with all Autopage serial data modules and is not
included with the
with all C I 3 compatible components. C I 3 Telematics system is available at
any authorized Autopage dealer.
This port will only operate correctly with Autopage C3 I-Datalink Modules
PROGRAMMING TRANSMITTER:
Note: This mode will only retain the last 4 remote transmitters programmed. If
the transmitter memory is exceeded, the security system will start deleting
transmitters from memory in chronological order.
1. Turn the Ignition 'switch 'OFF/ON' 3 TIMES and stay in ON position.
"Within 15 seconds".
2. Push the Valet switch 2 times and hold it on the 2
heard then release the valet switch. You are now in the Transmitter
programming mode.
3. Press and hold any button of the transmitter until the siren responds with a
confirming chirp, indicating the signal has been stored into memory.
4. If you have additional transmitters (up to 4) that need to be programmed,
repeat step 3 for each transmitter.
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3
parking light flashes will confirm exit.
FEATURE "A" PROGRAMMING:
1.
Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times (holding in on the 3rd push) until one
chirp with a long chirp is heard, then release the valet switch. You are
now in Alarm feature 'A' programming mode.
3. Press and release the transmitter button corresponding to the feature
you want to program. (See chart on next page)
The siren chirps and LED pulse will indicate new setting.
The factory default settings are always [1] LED flash, [1] siren chirp.
4. Depress the transmitter button to change the feature.
re-depressing the transmitter button again until the module advances
to your desired setting.
a. In this case, Press the button again, the module will advance
to [2] LED flash, [2] horn chirp.
b. Press the button again; the module will advance to [3] LED
RS-622.
This two-way data port has been designed for use
PROGRAMMING
FEATURE PROGRAMMING:
RS-622.
nd
19
This will provide greater
push until a long chirp is
Simply keep
.
Hide quick links:
Advertisement
Table of Contents
