Autopage C3-RS-625 Installation Manual page 10

H3. 4-PIN BLACK CONNECTOR. –
TWO-WAY TRANSCEIVER/ANTENNA MODULE
The Two-way
location should be the upper left or lower left
corner of driver's windshield. For optimum range
we suggest that the antenna be mounted as
shown in picture to the right. (Antenna tip facing up)
Warning!
Do not mount in such a manner that it obstructs
the driver's view.
- Remove the protective tape backing.
- Carefully align the two-way transceiver/antenna and apply to windshield.
- Route the black connector wire behind the trim and connect to the two-way
transceiver/antenna.
- Connect the other end to the control module.
- Special considerations must be made for windshield glass as some newer
vehicles utilize a metal-shielded window glass that will inhibit or restrict RF
reception. In these vehicles, route the two ways transceiver/antenna module
away from metallic shielded window glass as far as possible.
H7: 14-PIN MOLEX WHITE CONNECTOR WIRE HARNESS:
ORANGE WIRE – (-) 500ma GROUNDED OUTPUT WHEN
ARMED
This wire will become grounded when the alarm is armed. The current
capacity of this wire is 500mA. This output can control starter disable.
H7/1 : ORANGE wire
from control module
H1/1 VIOLET wire (Starter output)
form Heavy Gauge wire harness
transceiver/antenna
IN4003 Diode
87
86
White wire
87a
30
mounting
Violet wire
85
Red wire to
Ignition Switch
"Off"
"Acc"
Yellow wire
10
"On"
Cut
X
"Start"
Starter