Autopage C3-RS-625 Installation Manual page 16

BLUE/BLACK WIRE : 200 mA (-) Second Accessory Output
This wire will provide a negative output that can be used as a second
accessory wire if necessary to operate climate controls or other
accessories after remote start has started the engine of the vehicle.
BROWN/BLACK WIRE : 200 mA (-) Ground Output When Running.
This wire provides a negative output during the remote start process. It
can be used to operate by-pass modules that may be required in your
installation. This wire will provide ground once the remote start process
has been initiated and will remain grounded while the engine is running.
H4. 2 PIN BLUE CONNECTOR FOR THE VALET SWITCH:
Select a mounting location for the switch that is easily accessible to the
driver of the vehicle. The switch does not have to be concealed, however,
concealing the switch is always recommended, as this provides an even
higher level of security to the vehicle. Mount the valet switch in a hidden
but accessible location. Route the valet switch wires to the control
module.
H6. 3 PIN DOOR LOCK CONNECTOR
NEGATIVE TRIGGER DOOR LOCK SYSTEM
POSITIVE TRIGGER DOOR LOCK SYSTEM
Blue Wire Door Unlock
Green Wire Door Lock
Blue Wire Door lock
Green Wire Door Unlock
To Exiting
Door Lock Relay
To Exiting
Door Lock Relay
16
Locking
Master
Switch
Locking
Master
Switch
+ 12V