Start Feature 'D' Programming; Tachometer Learn Type; Tachometer Checking Type - Autopage C3-RS-665 Installation Manual

START FEATURE "D" PROGRAMMING:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF
position.
2. Push the Valet switch 9 times (holding in on the 9TH push) until four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature 'D' programming mode.
3. Press and release the transmitter button corresponding to the feature
you want to program.
Press One Chirp /
Transmitter LED one pulse
Button Factory Default
Setting
Exit the programming mode.
1
(3 long chirp & 3 parking light flashes to confirm this exit.)
Tachometer
2 +
Check type (3A)
A> RPM learning – see RPM Learning page 23.
B> Start Crank
3
Time:
0.6-second
Low check level
4
Start or Stop the system for TESTING & ADJUSTMENT
5
Test mode Zone 2/3
6 +
Door Trigger
+ 50 RPM
7 +
DBI ONLY
- 50 RPM
8 +
DBI ONLY
Exit: Press the
light flashes will confirm exit.
Enter Start Feature 'D' Programming Mode:
1. Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay in OFF position.
2. Push the Valet switch 9 times (holding in on the 9th push) until four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature 'D' programming mode.
Select "Checking Type":
3. Press and release the transmitter
"Tachometer Checking Type". [1] LED flash, [1] Siren chirp to confirm
REMOTE START FEATURE PROGRAMMING:
button on the transmitter. 3 long chirps & 3 parking

TACHOMETER CHECKING TYPE:

Two Chirps /
LED two pulse
Voltage check
type (go to 3B)
0.8-second (2 chirps), 1.0-second (3 chirps),
1.2-second (4 chirps), 1.4-second (5 chirps),
1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps),
4.0-second (10 chirps),
Hi check level
Test W/A (zone1)
P/S# (zone 4)
No RPM learning
No RPM
Learning or <
50RPM
+
23
Three Chirps / Four Chirps /
LED three LED four
pulse pulse
Timer
checking type
(go to 3B)
button once to set the