Introduction - Yunca Gas entis Installation & Operation Manual

entis INTRODUCTION
Welcome, and congratulations on purchasing your YUNCA entis (Fuzzy Logic) FLUED
GAS HEATER.
Please read the following carefully before attempting to operate the heater and ensure all members of
your home understand how this elegant and highly efficient heater functions.
Please fill out and return the registration card promptly (back page).
These instructions should be stored in a convenient safe place for ready reference. If you have any
questions regarding your heater please contact your YUNCA dealer.
(FuzzyLogic Control)
The YUNCA entis
room heater tested by independent laboratories to Australian and New Zealand standards.
Electronic ignition and operation is by an infra-red remote control hand piece (pages 13-15). However
if your remote is mislaid or damaged there is a convenient manual control panel (page 12) in the right
hand side of the air vent, below the fascia panel. Both the remote and the control panel feature "kiddy-
lock" controls for added peace of mind.
The Yunca entis incorporates a two-speed automatic fan boost. We highly recommend the use of the
fan boost for greater heating efficiency. When the firebox is at an optimal temperature an automatic
sensor starts the fan (on low or high speed depending on the setting, refer diagram below). Note: The
fan will continue to run until the unit has cooled down. If the fan is not required then having the switch
in the middle position will turn the fan boost off.
Should power not be available for any reason, battery back up through two "D" sized batteries ensures
the fire will continue to operate (without the fan boost). Ref page 12.
The installation of the YUNCA entis FLUED GAS HEATER must be carried out by a suitably qualified
person and comply with the current New Zealand installation code, NZS 5261:2003/AG 601:2002.
CAUTION: This appliance must be flued to atmosphere.
Installation and repair of the YUNCA entis GAS HEATER must be carried out by a qualified person.
The appliance should be serviced at least annually by a qualified service person. Control
valve compartments, burners, fan, and air circulating passageways of the entis must be kept
free from any lint and dust build-up to ensure efficient and safe operation of the heater.
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
(This particularly applies to the remote control handpiece!)
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE
Revised 22-08-07
FLUED GAS HEATER is a gas-fired, conventionally vented,
low (auto)
left middle
APPLIANCE.
WHILE IT IS OPERATIONAL.
Yunca entis instal Aug07
off high (auto)
right
Page 3 of 23