Yunca Gas entis Installation & Operation Manual page 14

AUTO FUNCTION CONTINUED: Once the times are set, press the grey AUTO SET button and leave
the remote near, but not on, the fire or the fire will not operate automatically. When the AUTO SET
button is pressed you will hear a long beep. When the fire is not operating the green light on the front
control panel (Page 12) will flash slowly to show AUTO is set, and you will see the AUTO symbol display
on the LCD screen of the remote control unit.
IMPORTANT:
Press AUTO SET button again to cancel the auto feature or the fire will continue to
run on the automatic settings, even if the remote is "off".
NOTE – Even when AUTO SET is activated (i.e. the display shows AUTO on the remote and the
green light on the fire is flashing) you can continue to operate the fire (i.e. turn it on and off, change
mode and heat output) without affecting the automatic feature settings. You are effectively
temporarily overriding the automatic control, e.g. if you wish to stop the fire running at an earlier
time.
Yunca entis instal Aug07 Page 14 of 23
Revised 22-08-07