ENTIS FASCIA REMOVAL AND APPLICATION
GLASS DOOR REMOVAL
When fitting the door, put the wing
nuts on in a sequence of opposite
corners. i.e. bottom left hand then
top right hand etc.
Remove the wing nut at each corner of
the door, and carefully pull forward.
Note:
The glass door can only be
removed after the heater has been
turned off for long enough so that the
door has cooled to a safe temperature
Revised 22-08-07
Reverse this sequence to reapply the fascia
Yunca entis instal Aug07
Push fascia upwards, this
lifts the locating pins clear of
the locating holes
Pull the fascia forward
and remove
Note: holes for seismic restraint
Page 5 of 23