Table of Contents
Advertisement
MAINTENANCE –cont.
The following procedures should be performed only by a qualified service person. The
gas supply and electrical power should be isolated whenever any maintenance
procedures are undertaken.
CLEANING THE LOG SET AND FIREBOX
During the annual inspection and maintenance appointment, the service person should clean
dust, lint and any light soot accumulation from the logs and the fire box area. An extra soft
brush should be used on the logs, as they are extremely fragile. If at any time the logs cannot
be removed or installed without force, the cause must be found. The logs must never be forced.
Procedure:
1. Remove glass door as described on page 5.
2. Remove the complete log set from the firebox by lifting it up and out. Brush it gently over a
newspaper and carefully place it out of the way.
3. The bark tray and heat baffle can be removed by undoing the attachment screws and lifting
out.
4. With firebox empty, a vacuum cleaner can be used to remove any visible dust and lint from
within the firebox area.
5. Replace the heat baffle and bark tray.
6. Replace log set.
7. Replace the glass door.
INSPECTING THE VENTING
An inspection of the venting system should be made during the annual service appointment.
There must be no blockages and the flue must be in good repair. Any sections that are
taken apart for inspection must be reassembled and sealed as required.
PARTS LIST
PART NO.
6601
6699L
6602
6680
6611G
6699
1608EE
1610EIB
1611EE
1955
8950Fz
Revised 22-08-07
PART NAME
Main Burner - SIT W-351120
Front Burner - Furi316
Pilot assembly
Flame rod lead
Spark electrode lead
Cross ignition channel
Control Valve BK368
Otago Bay Log Set assembly
Fan assembly QLZ06/1200 A49
Door gasket
Glass
Glass thermotape seal
Rocker switch
Fascia front (State Colour)
Fascia backing frame (State Colour)
Main door (State Colour)
Combustion Plate
Remote control hand piece (Fuzzy Logic)
Yunca entis instal Aug07
.
Page 17 of 23
Advertisement
Table of Contents
