Error Codes - Whirlpool Rooper Service Manual

NORMAL CODES
The microcomputer contains self-diagnostic
codes that will be displayed on the control
panel whenever a failure occurs when using
4-Digit 3-Digit
Display Display
E0 E0 E0 E0 E0
F1 F1 F1 F1 F1
E1 E1 E1 E1 E1
E2 E2 E2 E2 E2
E0 E0 E0 E0 E0
F2 F2 F2 F2 F2
E1 E1 E1 E1 E1
E0 E0 E0 E0 E0
F3 F3 F3 F3 F3
E1 E1 E1 E1 E1
E2 E2 E2 E2 E2

ERROR CODES

Likely Cause
EEPROM communications.
EEPROM checksum failure.
UL A/D error(s).
Shorted keypad.
Keypad cable unplugged.
Oven sensor opened.
Oven sensor shorted.
Bake range overtemp.
4-15
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
the range. Each code can be cancelled by
pressing the CANCEL/OFF keypad. The code
will return if the user attempts to use the range
before the failure has been corrected. All error
code data is shown below.
Corrective Action
1. Use the CANCEL/OFF keypad and verify the failure (if
not displayed).
2. Disconnect the power for at least 30-seconds and re-
check.
1. Use the CANCEL/OFF keypad and verify the failure (if
not displayed).
2. Disconnect the power for at least 30-seconds and re-
check.
3. Make sure that keypad cable is plugged in and seated in
connector on back of control.
4. Reapply power and observe for a minimum of 1-minute.
5. If failure remains, replace the control.
1. Measure the sensor value between the connector pins.
You should measure between 1000Ω @32˚F and 2697Ω
@ 900˚F. If the measurement does not correlate to real
temperature, replace the sensor, and reference steps 3
through 5.
Also measure from the sensor connector to the sensor
casing for a possible short.
2. Trace the wires and connectors to the sensor from the
control, then from the sensor back to the control.If all
connections are okay and there is no wire damage,
reference step 3 through 5.
3. Disconnect the power for at least 30-seconds.
4. Reapply power and observe for a minimum of 1-minute.
5. If failure remains, replace the control, and then repeat
step 4.
4321892
Page 4-15