Removing/Reinstalling The Oven Door - Whirlpool Rooper Service Manual

REMOVING/REINSTALLING THE OVEN DOOR

To remove the oven door:
1. Open the door approximately half way and
install a nail or screw into the hinge hangers
on each side of the door. Do not remove
them while the door is removed from the
range.
insert nail or
screw here
oven door
2. Close the oven door as far as the nails or
screws will allow.
3. Grasp the sides and lift the door until it stops,
then rotate the door toward the floor, and pull
it toward you. IMPORTANT: Do not use the
door handle to lift the door.
oven door
To reinstall the oven door:
1.
range
2.
3.
hinge hanger
4.
5.
ROTATE
6.
range
LIFT
1-14
Grasp the sides of the door with your fingers
on the front of the door and your thumbs on
the inside surface.
Rest the bottom of the hinge hanger on the
bottom of the slot in the range.
Position the door with the hinge hanger slots
almost parallel to the front frame.
Push up and in until the hinge hanger slots
become fastened to the range, then lower the
door, and rotate it slightly from the front to the
back until the slots are fully fastened. The
hinge hanger will be close to the bottom of the
front frame slot.
remove screw or nail
front frame slot bottom
Pull the door open about half way and remove
the nails or screws.
Close the door.
range
hinge
hanger
hinge
hanger flat