Failure Codes & Reference Data - Models Rs610Pxew & Rs610Pxen - Whirlpool RS610PXE Job Aid

FAILURE CODES & REFERENCE DATA
Models RS610PXEW & RS610PXEN
FAULT CODE ERROR CODE
- F0 - All E-Codes
- F1 - All E-Codes
- E0 -
- F2 -
- E2 -
- E0 -
- E1 -
- F3 -
- E2 -
- E3 -
- F6 - - E0 -
NOTES:
1. The most common cause for control failure is corrosion on connectors. Therefore, disconnecting and recon-
necting wires will be necessary during test procedures.
2. All tests should be made with a VOM or a DVM having a sensitivity of 20,000 ohms per volt DC, or greater.
3. Check all connections before replacing components. Look for broken or loose wires, defective terminals, or
wires not pressed into the connector far enough.
4. Voltage checks must be made with all connectors attached to the boards.
5. Resistance checks must be made with power cord unplugged from outlet and with wiring harness or connec-
tors disconnected.
MEANING OF
FAILURE CODE
Default F-Code
no failure.
Electronic control malfunction.
Keypad not connected.
Key held down too long or key
is shorted.
Temperature sensor opened.
Temperature sensor shorted.
Oven temperature too high.
Return line not connected.
- 20 -
REPAIR PROCEDURE
Will only be displayed if user presses and holds Cancel key
for 5-seconds and there is no pre-existing fault. Press
Cancel key again to clear display.
Replace control if the E-Code is not E3.
Check keypad connector for firm connection.
Press Cancel key. If error code returns after 60-seconds,
replace keypad.
Check sensor connection.
Measure sensor resistance (1080 ohms @ 70˚F; add 2
ohms per degree).
If resistance is not valid, replace sensor.
If sensor resistance and connections are okay, then the
oven cavity temperature must have exceeded a safe level.
Check for relay contacts welded together on control board.
If switch pulse return line is not connected, electronic
control will display F6 within 60-seconds after power-up.