Whirlpool Rooper Service Manual page 31

5. Remove the two screws from the bracket of
the hot surface indicator light.
6. Remove the screws from the element retain-
ing brackets, unhook them from the maintop,
and remove them.
7. Clean the bottom glass of the new maintop
and remove any debris.
BRACKET SCREW
ELEMENT
IF NECESSARY,
UNHOOK THIS END
TO REMOVE BRACKET
GROUND SCREW
RETAINING
BRACKET
BLUE
WHITE
ELEMENT
BLUE
(2) BLACK
BLACK
BROWN
BLACK
BROWN
(2) BLACK
BLK
HOT SURFACE INDICATOR
LIGHT BRACKET
& SCREWS
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
8. Lift the elements off the old maintop and place
them on the new maintop at the same loca-
tions.
9. Install the new maintop and reassemble the
range. REASSEMBLY NOTE: When reinstall-
ing the maintop, make sure that it is centered
on the range, that the side brackets are en-
gaged, and that the rear side flanges are
inside the end caps.
BRACKET SCREW
(2)
BLACK
YELLOW
BLACK
BLACK
(2)
BLACK
ORANGE
ELEMENT
WHITE
ORANGE
CERAN GLASS
MAINTOP
3-5
4321892
Page 3-5
RETAINING
BRACKET
BLACK
ELEMENT
YELLOW
IF NECESSARY,
UNHOOK THIS END
TO REMOVE BRACKET