Installation Highlights; Range Dimensions - Whirlpool Rooper Service Manual

INSTALLATION HIGHLIGHTS

GENERAL
Proper installation is your responsibility. A quali-
fied technician must install this range. Make sure
you have everything necessary for correct installa-
tion. It is the responsibility of the installer to comply
with the installation clearances specified on the
model/serial rating plate. This plate is located on
the frame behind the storage door panel. The
range dimensions are shown below. IMPORTANT:
Be sure to observe all governing codes and ordi-
nances.
27-1/8 " depth
with handle
24-13/16 "

RANGE DIMENSIONS

29-7/8 " width
1-1
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
MOBILE HOME INSTALLATION
The installation of this range must conform with the
Manufactured Home Construction and Safety Stan-
dard, Title 24 CFR, Part 3280 (formerly the Federal
Standard for Mobile Home Construction and Safety,
Title 24, HUD, Part 280), or when such standard is
not applicable, the Standard for Manufactured
Home Installations, ANSI A225.1/NFPA 501A, or
with local codes.
When this range is installed in a mobile home, it
must be secured to the floor during transit. Any
method of securing the range is adequate as long
as it conforms to the standards listed above.
A 4-wire power supply cord or cable must be used
in a mobile home installation. The appliance wiring
will need to be revised (see "4-Wire Electrical
Connections" on page 1-7).
Copies of standards listed may be obtained from:
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
46-7/8 "
overall
height
36 "
cooktop
height
4321892
Page 1-1