Furuno FELCOM 250 Operator's Manual page 143

The following is a list of Error and Warning messages. An Error message appears
when a critical error occurs, and the unit can not function. A Warning message is dis-
played when an error occurs, and the unit can only operate with limited function.
Perform a general inspection of the unit. When an Error/Warning message appears,
do the following.
• Reset the power.
• Make sure all cables and connectors are correctly connected.
• If the normal operation cannot be restored, contact a service technician. Report the
error messages to the technician.
Error
Type
Code
9001 Error
9201 Error
9202 Error
9204 Error
9209 Error
9214 Error
9301 Error
9303 Error
9304 Error
9305 Error
9306 Error
9307 Error
9308 Error
9309 Error
9314 Error
9401 Error
9402 Error
9101 Warning
9102 Warning
7. MAINTENANCE AND TROUBLESHOOTING
Message
Connection Failure
between Comm
Unit and Ant. Unit.
PoEthernet total
output fault.
PoEthernet port out-
put fault.
Invalid MAC ad-
dress. Please con-
tact FURUNO
service.
FPGA fault
Audio Codes initial-
ization fault.
FPGA fault.
Loading DSP1 fault. DSP1 loading error.
DSP1 fault.
Loading DSP2 fault
DSP2 fault
Loading DSP3 fault. DSP3 loading error.
DSP3 error.
HPI fault
Invalid IMEA data.
Please contact FU-
RUNO service.
Rx PLL unlock.
Tx PLL unlock.
Cable calibration
fault.
Fan fault.
Cause
ADE not connected.
PoE exceeds 30W.
PoE port failure (when provi-
sioning PoE of different
class).
MAC address is invalid.
(Check MAC address of
HUB.)
FPGA error.
Audio Codes initialization
fault.
FPGA error.
DSP1 error.
DSP2 loading error.
DSP2 error.
DSP3 error.
HPI error.
IMEI writing error.
Rx PLL unlocked.
Tx PLL unlocked.
Cable not calibrated.
Fan fault.
Location
of error
ADE
HUB
HUB
HUB
HUB
HUB
Modem
Modem
Modem
Modem
Modem
Modem
Modem
Modem
Modem
IF
IF
HPA
HPA
7-9