Honeywell MX7 Reference Manual page 254

Parameter Default
WMM Off
Auth
Type 1
Server
TTLS Inner
Auto-EAP
Method
PMK Cach-
Standard
ing
WAPI Off
BG: On
TX
A: Main
Diversity
Only
The options for the TX Diversity parameter should be set, based on the antenna configuration, as follows:
Antenna Configuration TX Diversity
A Main and BG Main
A Main and A Aux
BG Main and BG Aux
Contact your representative
7-16
roaming, AP specified maximum transmit power and radio management.
Off - Do not use Cisco IE and CCX version number.
Cisco IE = Cisco Information Element.
Use of Wi-Fi Multimedia extensions. Devices running Windows CE OS cannot change the default
value.
Options are: On, Off
Specifies the type of authentication server.
Options are: Type 1 (ACS server) and Type 2 (non-ACS server)
Authentication method used within the secure tunnel created by EAP-TTLS.
Options are: AUTO-EAP (Any available EAP method), MSCHAPV2, MSCHAP, PAP, CHAP, EAP-
MSCHAPV2
Type of Pairwise Master Key (PMK) caching to use when WPA2 is in use. PMK caching is designed
to speed up roaming between APs by allowing the client and the AP to cache the results of 802.1X
authentications, eliminating the need to communicate with the ACS server. Standard PMK is used
when there are no controllers. The reauthentication information is cached on the original AP. The
client and the AP use the cached information to perform the four-way handshake to exchange keys.
Opportunistic PMK (OPMK) is used when there are controllers. The reauthentication information
cached on the controllers. The client and the controller behind the AP use the cached information to
perform the four-way handshake to exchange keys.
If the selected PMK caching method is not supported by the network infrastructure, every roam
requires full 802.11X authentication, including interaction with the ACS server.
If the active profile is using WPA2 CCKM, the global PMK Caching setting is ignored and the client
attempts to use CCKM.
Options are: Standard, OPMK
Note: This change does not take effect until after a Suspend/Resume cycle.
Default is Off and dimmed (cannot be changed).
How to handle antenna diversity when transmitting packets to the Access Point.
Options are: Main only (use the main antenna only), Aux only (use the auxiliary antenna only), or On
(use diversity or both antennas).
Main Only
On
On
if you have questions about the antenna(s) installed on your MX7.
Function