Avalanche Update Using File > Settings; Menu Options - Honeywell MX7 Reference Manual

Avalanche Update using File > Settings
Use these menu options to setup the Avalanche Enabler on the MX7. Always change settings and then save the changes
(reboot) before connecting to the network.
Alternatively, the Mobile Device Server can be disabled until needed (refer to the Wavelink Avalanche Mobility Center
User's Guide for details).

Menu Options

Note: Your MX7 screen display may not be exactly as shown in the following menu options. Contact your
representative for version information and upgrade availability.
Connection
Execution
Data
Server Contact
Startup/Shutdown
Preferences
Taskbar
Scan Config
Display
Shortcuts
SaaS
Adapters
Status
6-10
Enter the IP Address or host name of the Mobile Device Server. Set the order in which serial ports or
RF connections are used to check for the presence of the Mobile Device Server.
Not available in this release. Use AppLock, which is resident on each Windows device.
Control when data is transferred between the device and the Mobile Device Server.
Setup synchronization, scheduled Mobile Device Server contact, suspend and reboot settings.
Set options for Enabler program startup or shutdown. Replaced by Preferences and Taskbar tabs in
some versions of Enabler.
Set options for Enabler startup or shutdown and logging. Replaces Startup/Shutdown tab in some
versions of Enabler.
Set options for Taskbar. Replaces Startup/Shutdown tab in some versions of Enabler.
This option allows the user to configure Enabler settings using a special bar code that is created by
the Avalanche MC Console. Scan Config not currently supported.
Set up the Windows display at startup, on connect and during normal mode. The settings can be
adjusted by the user.
Add, delete and update shortcuts to user-allowable applications.
Configure the Enabler to connect with Avalanche on Demand.
Enable or disable network and wireless settings. Select an adapter and switch between the
Avalanche Network Profile and manual settings.
View the current adapter signal strength and quality, IP address, MAC address, SSID, BSSID and
Link speed. The user cannot edit this information.