Table of Contents
Advertisement
4.4.3 Removing transportation safety bolts
1 Loose all transportation safety bolts with an appropriate wrench until they turn
freely
.
(C)
2 Remove the transport safety bolts by turning them slightly.
3 Insert the plastic covers in the bag containing the user manual to the openings
on the rear panel.
A
CAUTION:
Otherwise, the product will be damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the product needs to be
moved again in the future.
Install the transport safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
4.4.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 10
MPa). It is necessary to have 10 – 80 liters of water flowing from the fully open tap in 1
minute to have your product run smoothly. Attach a pressure reducing valve if water pressure
is higher.
A
CAUTION:
In such a case the laundry will get damaged or the product will switch to protection mode
and will not operate.
CAUTION:
stains on your laundry.
1 Tighten the nuts of the hose by hand. Never use a tool when tightening the
nuts.
2 When hose connection is completed, check whether there is leak problems at
the connection points by opening the taps fully. If any leaks occur, turn off the
tap and remove the nut. Retighten the nut carefully after checking the seal. In
order to prevent the water leaks and resultant damages, keep the taps closed
when you do not use the product.
Washing Machine / User's Manual
(P)
Remove the transportation safety bolts before operating the product!
Models with a single water inlet should not be connected to the hot water tap.
Do not use old or used water inlet hoses on the new product. It may cause
13 / EN
Advertisement
Table of Contents
