Connection To Squid Fishing Gear - JRC JFV-130HP Series Installation Manual

2.9.4 Connection to Squid Fishing Gear

Be sure to select "Display" for the cursor display. If you turn on the
function when "Off" is selected, improper data can be generated.
Bubbles or thick plankton layer in the upper surface can prevent
determining state of sea bottom. In such case, the cursor position
water depth data shall be used.
Prior to the connection, you must confirm the squid fishing gear
maker if the sensor can be connected to it.
Depth of sea bottom or at cursor position can be output to the squid fishing gear.
Switching between the sea bottom depth and the cursor position depth is done from the
squid fishing gear.
This function is not available for a squid fishing gear that does not accept
signal in the NMEA0183 format. Contact our Marketing people for the fol-
lowing software that can establish connection between such machine:
SE50/SE60 from Sanmei Marine Co. designed for a squid fishing
gear requiring software replacement.
When three or more outputs are read in parallel, you need to connect the buffer (sepa-
rately available NQA-602DC).
When generating output of the cursor position water depth, select "Display" of the cursor.
(1) Connecting procedure: See Figure 2.3.
Connect the J907 ‡D (OUT) to "NMEA +in" of the NMEA input from the external
equipment.
Then, connect the J907 ‡A (GND) to "NMEA -in" of the NMEA input from the external
equipment.
(2) Setup procedure
Select "9. Screen Display" from the main menu, then select "Display" from the sub-
menu "5. Cursor Display" (the system is initially set to the "Display").
For the operation, see page 23 in the Instruction Manual.
CAUTION
27