Connecting The Remote Controller (Nch-466E); Connecting The S.split Signal (Telefinder); Output To The Telefinder ¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥ ¥¥¥¥28 - JRC JFV-130HP Series Installation Manual

2.10 Connecting the Remote Controller (NCH-466E)

The JFV-130HP accepts connection of the optional remote controller.
The remote controller allows you to record or reproduce the screen data, and generat-
ing the water temperature and the water depth alarms.
For the operation, see page 38 in the Instruction Manual.
Connecting procedure:
Connect the connector to J907.

2.11 Connecting the S.Split Signal (Telefinder)

The JFV-130HP is capable of outputting the transmission trigger or fish finding signal
to an external monitor. And, accepting the external transmission trigger or the fish
finding signal, the JFV-130HP can use it as the monitor.
Whenever establishing this connection, attach the clamp filter, then fix it by turning the
S.Split signal cable on it once.
2.11.1 Output to the Telefinder
The JFV-130HP outputs the transmission trigger and reception signal to establish con-
nection between the external monitor.
Connection procedure: Connect the JFV-130HP to J908. See Figure 2.4 in page
Trigger output TTL level
Signal output 0 to 4V
External view of the remote controller
Clamp
¸×ÝÌß̨ÙÀ
filter
A single turn on the clamp filter ‚P‚"•@¹°ÌÞÙ‚ðŠª‚-
31 for the detail. The transmission trigger is output at its
TTL level and the signal is output at 4V maximum.
28