Table of Contents
Advertisement
Setup Procedure
Select "9. Screen Display" from the main menu, then select "Display" for the cursor
from sub-menu "5. Cursor" (the system is initially set to "Display").
For the operation, see page 23 in the Instruction Manual.
2.9.3 Input of Water Temperature Data (NMEA type sensor)
The JFV-130HP allows to connect a water temperature sensor designed for the NMEA
output format. In this case, the water temperature display position must be switched
from "Upper Left" to "Lower Right" side.
When a thermistor type water temperature sensor (see Section 2.8) is connected, dis-
play of water temperature data from a NMEA type sensor is disabled.
Connecting procedure: See Figure 2.3.
Connect the J907 ‡C (NMEA +in) to "NMEA OUT" of the NMEA output from the ex-
ternal equipment.
Then, connect the J907 ‡B (NMEA -in) to "NMEA GND" of the NMEA output from the
external equipment.
Display Setup
Select "9. Screen Display" from the main menu, then switch the display position from
"Upper Left" to "Lower Right" using the sub-menu "1. Water Temperature Value Dis-
play Position" (the system is initially set to "OFF").
For the operation, see page 20 in the Instruction Manual.
‚i‚X‚O‚V•@CONXALLƒRƒlƒNƒ^
J907 CONXALL connector
•@•@•@DEPTH•@OUT
GND
3
NMEA -in
NMEA +in
+12V
1
2
6
NC
4
5
OUT
Figure 2.3 Connecting Temperature Input
26
Note:
1.
The following pin number arrange-
ment is the one seen from the sol-
dered surface side.
2.
Users are required to separately
procure the connector as an inter-
face mounting part (stock code:
7ZZBS0001).
Advertisement
Table of Contents
