Install Memory - Mercury KOB 810e FST User Manual

Mainboard User's Manual
3. On the Socket-370, identify the Pin-1 corner. The Pin-1 corner
is at the end of the locking lever when it is locked.
4. Match the Pin-1 corners and insert the processor into the
socket. No force is required and the processor should drop into
place freely.
5. Swing the locking lever down and hook it under the catch on
the side of the socket. This secures the CPU in the socket.
6. All processors should be installed with a combination
heatsink/cooling fan, connect the cable from the fan to the
CPU fan power connector.

Install Memory

The mainboard has two DIMM sockets for system memory
modules. You must install at least one memory module in order to
use the mainboard.
For this mainboard, you must use 168-pin, 3.3V unbuffered
SDRAM memory modules. If the installed CPU uses a 66/100
MHz system bus, you must use PC100/PC133 memory. If the
installed CPU uses a 133 MHz system bus, you must use PC133
memory. You can install any size memory module from 8 MB to
256 MB, so the maximum memory size is 2 x 256 MB = 512 MB.
The edge connectors on the memory modules have cut outs, which
coincide with spacers in the DIMM sockets so that memory
modules can only be installed in the correct orientation.
10
DIMM1
DIMM2